Pi Pico Development board with Breadboard
Pi Pico Development board makes developing with the Pico an easy task.
The board includes a bread board for mounting various components. Jumper
wires can be attached to all the available Pico GPIO pins and power via
the male headers.
included are 8 X LED's for GPIO monitoring and 4 X push button switch,
connections to these are through male headers on the board. A buzzer is
board also incorporates a reset button for the Pico, this avoids
pulling out the USB connector and reinserting when you need to upload a
UF2 file. Just hold down the bootsel button and press reset button.
Raspberry Pi Pico Compatible
Reset button on board
2 x 20 Male Pin Headers for Jumper Wires
2 x 20 PCB solder connections.
All Raspberry Pi Pico Pin identifications marked on Development board.
456 Tie Point Breadboard, 2.54mm pitch.
2 x 20 pin female headers supplied to solder to breakout board if required.
8 X GPIO LEDS
4 X Push button switches
1 X 3.3V - 5V Buzzer
Board size 133mm x 90mm
Interface using female jumper cables or male jumpers with supplied female headers soldered
Easy Pico programming using the on board reset switch.